Account inloggen

BISHTA - Promoting safe spa water

Balboa Approved Stockist

HydroAir Approved Stockist

Pool and Spa Scene

1.5 inch 100gpm Suction Assembly Grey (DISCONTINUED)
1.5 inch 100gpm Suction Assembly Grey (DISCONTINUED)
Artikelnr.: PL-10377


Type of product: Suction
Specification and colour: 1.5" S - Grey
Most common size reference: 1.5 inch - 
Overall outer dimensions approx: Diameter of face: 97mm
Height if stood on its face: 105mm
Internal diameter size:  
Fits hole size: 60mm
Optimum flow rate: 100 gallons per minute. When using a specific suction you should take in to account the required flow intake for the pump you will be plumbing to and also the heater. On ALL systems it is required by BISHTA standards to install 2 suctions per pump to avoid entrapment and or disembowelment.
Commonly used with: 1.5 inch rigid pipe and 1.5 inch flexible rigid pipe.
Additional notes: Best to use a plumbing cleaner then pipe cement to assemble. Pipe work pushes inside this part at the female end.

Assemble through the spa shell with silicone, you can use a gasket instead of the silicone but not both together as this often causes the gasket to spurge out the side and would cause a leak.